Knob-and-Tube Replacement in Toronto

Inspection and rewiring for older homes in the Annex, Seaton Village, Harbord Village and Casa Loma, replacing original knob-and-tube with grounded circuits while keeping plaster and trim intact.

Call 647-694-5135

Knob-and-Tube Wiring in Midtown Toronto Homes

Many houses around Spadina and Bloor were built between the 1880s and the 1920s, and a lot of them still have some original knob-and-tube in service, usually feeding upstairs bedrooms or ceiling lights. It has no ground, its insulation turns brittle with age, and where it has been covered with attic insulation it can run hot. Most insurers now ask about it, and many will not cover a house with live knob-and-tube unless it is being replaced.

Inspection First

We trace every circuit from the panel and check the attic, the basement and a sample of outlets and fixtures, so you know exactly how much knob-and-tube is still live before any work is priced.

Rewiring Without Gutting Walls

New cable is fished through existing wall and ceiling cavities from the basement and attic. Where a run cannot be fished, we make small, planned openings that are easy to patch, with care for original plaster, mouldings and trim.

Room-by-Room Phasing

Most families stay in the house during the work. We rewire in stages and restore power to finished areas at the end of each day, disconnecting each old circuit at the panel as its replacement goes in.

Panel Upgrade and ESA Inspection

Homes with knob-and-tube often still have 60 or 100 amp service, so a rewire is a good time to upgrade the panel. All work is done under an ESA permit and inspected, which gives you the paperwork your insurer will ask for.

Electrical rough-in wiring during Toronto home renovation

FAQs — Knob-and-Tube Replacement Toronto

How do I know if my house has knob-and-tube?
Look in the basement or attic for single wires running on porcelain knobs or through porcelain tubes. Two-prong outlets throughout the house are another sign. An inspection confirms how much is still live.
How long does a knob-and-tube rewire take?
A few leftover circuits can take a day or two. A full rewire of a semi or detached house in the Annex or Seaton Village usually takes one to two weeks, depending on access and finishes.
Will my walls be damaged?
Very little in most cases. Older Toronto houses often have open wall cavities from basement to attic, which makes fishing new cable easier, and the few openings needed are planned for quick repair.
Will my insurer accept the work?
Insurers generally want proof that the knob-and-tube is removed or disconnected and that the work was inspected. The ESA documentation from the job covers that.

Ready to Replace Your Knob-and-Tube?

Call or text us with your address and a few photos of the panel and basement. We will explain what is involved and book an inspection.

Plan Your Knob-and-Tube Replacement

From electrical repairs and troubleshooting to lighting installations, panel upgrades and wiring, Electrician Experts Toronto is ready to discuss your electrical project.